Checks, in order
- Sway bar links and bushingsGrab the links and push or pull by hand with the truck on the ground, and look at the bushings for cracking or a gap around the bar. Loose links clunk at low speed over small bumps.easy $ · under about $50
- Loose wheels and lug nutsCheck lug nut torque and look for hammered wheel stud holes. A loose wheel clunks and can be dangerous.easy $ · under about $50
- Shocks and mountsLook for oil on the shock body, and check the upper and lower mounts and bushings for cracking or movement. Bounce each corner; it should settle in one rebound.easy $ · under about $50
- Rear leaf spring hardwareInspect the shackles, U-bolts and spring eye bushings for movement, cracks or rust. A cracked leaf or loose U-bolt knocks over bumps. Squeaks usually come from dry bushings or worn spring pads.medium $$ · about $50 to $500
- Control arm bushings and ball jointsPry the control arms and check for movement at the bushings and ball joints. Do this after the cheap checks above.medium $$ · about $50 to $500
Applies to: 1995.5 to 2004 Tacoma with the 2RZ-FE 2.4L, 3RZ-FE 2.7L and 5VZ-FE 3.4L V6, 2WD, PreRunner and 4WD. Code-based checks assume OBD-II (1996 and newer); earlier trucks may use a different diagnostic setup.
Tools and parts for these checks
Links below are Amazon affiliate links: as an Amazon Associate, toyotadata earns from qualifying purchases, at no extra cost to you. Confirm fitment for your exact truck before you order.
| ITEM | USED FOR | BUY |
|---|---|---|
| Pry bar set | Checking ball joints, bushings and tie rod ends for play | Shop on Amazon |
| Sway bar end links | A common clunk source and a cheap fix | Shop on Amazon |
| Outer tie rod ends | Replacing worn tie rod ends | Shop on Amazon |
| 1/2" drive click torque wrench | Tightening suspension and driveline bolts to spec | Shop on Amazon |
The same problem on other Toyotas
Other steering & suspension problems on the 1st Gen Tacoma
- Loose front end, steering wander or clunk from the lower ball joint (4WD/PreRunner)
- Steering feels loose or the truck wanders on the highway
More 1st Gen Tacoma problems
- Frame rust: flaking, holes or a soft frame (Frame & Body)
- Vibration at highway speed or under acceleration (Drivetrain)
- 4WD won't engage or front axle doesn't seem to drive (Front Axle)
- Whine, howl or clunk from the front or rear differential (Drivetrain)
- Engine overheating or temperature gauge climbing (Cooling)
- 5VZ-FE V6: timing belt due, ticking, or worried about the water pump (Engine)
All 16 1st Gen Tacoma symptoms in the interactive troubleshooter →
General guidance from owner experience. Confirm torque specs, fluid capacities and procedures in the factory service manual. Brakes, steering and anything structural: if in doubt, have a qualified shop inspect it before driving.